• To remove the cleaner from the pool using the remote
control, press
(see Figure 20).
The cleaner rotates left until you release the Lift
System button.
4.6 Synchronizing the Remote Control
Even though the remote control is factory-synchronized
to your cleaner's control box, it may be necessary to
synchronize again if you need to replace either the
control box or the remote control.
• To synchronize the remote control to the control box:
Press
and hold for 3 seconds to turn on remote.
Plug the control box into a power source.
When the display shows the operating time, press
and
simultaneously for six (6) seconds.
• The display shows
followed by the
normal operating time display to indicate the cleaner
is now synched with the remote and ready to begin
operating in remote control mode.
4.7 Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone
or its equivalent. Rinse the cleaner generously using
clean water. Do not let your cleaner dry in direct
sunlight near the pool.
NOTE:
It is recommended that the cleaner is stored on its
caddy for drying (see Figure 23).
1.
Disconnect the floating cable from the control
box. Replace the protective cap on the control
box.
2.
Starting at the cleaner head. Remove all coils
and tangles from the floating cable (Figure 22).
Figure 22. Smooth the Floating Cable
3.
Loosely coil the floating cable starting at the
cleaner and moving toward the connection point
at control box.
Figure 23. Cleaner Correctly Stored on Caddy
H0503800_REV A
12
