21
❻ Troubleshooti ng
• If a problem occurs, before you contact your retailer, please carry out these few simple checks
using the following tables.
• If the problem conti nues, contact your retailer.
•
: Acti ons to be performed by a qualifi ed technician only.
6.1 I Appliance behaviour
Part of the pool is not
correctly cleaned
•
Repeat the immersion steps (see § “3.3 I Immersing the cleaner"), varying the
immersion locati on unti l you fi nd the right place in the pool.
The appliance does not stay
fi rmly on the pool fl oor
•
There is sti ll air in the appliance's casing. Repeat the immersion operati ons (see §
“3.3 I Immersing the cleaner").
•
The fi lter is full or dirty: clean it.
•
The fi lter is clogged: change it.
•
The propeller is damaged:
The appliance does not or no
longer climbs the pool walls
as it originally did.
•
The fi lter is full or dirty: clean it.
•
The fi lter is clogged: change it.
•
The tyres are worn: replace them.
•
Even though the water seems clear, microscopic algae are present in your pool. They
are not visible to the naked eye, and they make the walls slippery and prevent the
appliance from climbing. Carry out shock chlorinati on and slightly reduce the pH.
Do
not leave the appliance in the water during shock treatment.
The appliance does not move
on start-up.
•
Check that the control box's power socket is receiving a power supply.
•
Check that a cleaning cycle has been launched and that the lights are on.
The cable gets tangled
•
Do not unroll the enti re length of the cable into the pool.
•
Place the required length of cable in the pool and spread the rest along the side of
the pool.
The control box does not
respond to any butt on
presses.
•
Unplug the power cord from the mains socket, wait 10 seconds and plug it back in
again.
If the problem conti nues contact your retailer:
