Page 47 / 47
Edition 3
E
N
G
L
I
S
H
TROUBLESHOOTING
IX- TROUBLESHOOTING
NOTE
: see Torqeedo’s user Manual, chapter
Troubleshooting
.
ERROR
CAUSE
CHECKING/CORRECTION
System display does not switch
on after turning the key switch
Circuit breaker is off
Check the boat circuit breaker and
switch it on if necessary.
Battery charge is too low
Check the charge state of the 12V
battery. If the charge is lower than
11V, charge using an external
charger unit if necessary.
Check the 50A fuse on the harness
and replace it if defective.
Bilge fan does not operate after
pressing the bilge fan switch
Circuit breaker is off
Check the boat circuit breaker and
switch it on if necessary.
Check the 50A fuse on the harness
and replace it if defective.
Bilge pump does not operate
after pressing the bilge pump
switch on Manual Mode
Battery charge is too low
Check the charge state of the 12V
battery and charge it if necessary.
Check the 5A bilge pump fuse and
replace it if defective
No water flow when the bilge
pump is running with water in
the bilge
Check the bilge pump strainer and
clean it out if necessary.
Reverser actuator does not
operate after pressing the tilt
button
Circuit breaker is off
Check the boat circuit breaker and
switch it on if necessary.
Battery charge is too low
Check the charge state of the 12V
battery. If the charge is lower than
11V, charge using an external
charger unit if necessary.
1- Check the 50A fuse on the
harness and replace it if defective.
2- Check the 16A actuator reverser
fuse and replace it if defective.
Boat slows down
Check the maintenance hydrojet
hatch and remove seaweeds or
debris if necessary. See chapter
“Propulsion”.