H0361200.E - EN - 2014-05
2
EN
1. Installati on and connecti ons
Check the directi on of the pipework connecti on (see installati on procedure).
Extending or shortening the hoses or using other hoses is prohibited. Check the
ti ghtening of the hydraulic connecti ons, and the presence of the joints for no leaks.
Only fi ll the hydraulic system using pool water or tap water.
•
You are recommended to fi x the head (I) on the end of the pool (15 mm minimum, 55 mm
maximum of end height) to ensure stability. Use the holes in the adjustment bases to fi t the
screws (not supplied),
•
Adjust the directi on of the head (I) using the wedges (G) and
adjustment bases (H) provided (see image 3). The adjustment
bases (H) can be positi oned in the 6 slots provided,
•
It is possible to fi x the hose att achments (D) to the ground
(brackets not included).
•
To keep an opti mum fl ow rate there must not be a diff erence
in level of more than 1.5 meters between the head (I) and the
«pump box» (J)
2. Starti ng the device
•
Check that the sucti on nozzle of the head (I) is not blocked,
Check this aspect regularly, the nozzle may be blocked.
•
Prime the hydraulic system (see procedures/images 7 - 11),
•
Start the heat pump (L) (refer to the heat pump manual for fi rst run and display),
•
This pump will automati cally detect the connecti on of the “pump box” (J), and the indicator
will light up:
,
•
Set the required water temperature,
•
Once the heat pump has started up, cut the water intake, shut valve (K) and disconnect the
fi lling hose (refer to images 12 and 13).
A ti me-delay of a few minutes may be applied for the heat pump at power-up.
The device may operate during bathing, and the use of the cleaning robot, however,
clean the wall behind the head on a regular basis.
If a roller cover is used for the pool, adapt the cover to the positi oning of the head (I),
or remove when closing the roller cover.
3. Winter storage
Winter storage is essenti al, otherwise the pump, hoses and head could freeze.
This
case is not covered by the warranty
.
•
Remove the head (I) from the pool,
•
Drain the head (I), hoses (A, B & C) and the “pump box” (J),
•
Store in a room which remains above freezing.
Summary of Contents for Easy Connect
Page 3: ...H0361200 E ML 2014 05 2 ...
Page 4: ...H0361200 E ML 2014 05 3 ...
