14
15
3/INSTALLATION
Important
For your own safety and for the CYBERNAUT NT ™ to work effectively, place the control box at least
3.5 metres
from the edge of the pool and where it will not be exposed to direct sunlight.
To ensure the robot runs at maximum effi ciency, position the trolley in the centre of the longest side
of the pool.
Electrical connection
Connect the robot power cable to the control
box and lock the connector in place beneath
the control box ; Only connect the control box
to an electrical socket protected by Residual Cur-
rent Device with a maximum rating of 30 mA (if
in doubt, contact a qualifi ed electrician).
4/IMMERSING THE ROBOT
Important
Under no circumstances should anyone be allowed to swim when the CYBERNAUT NT™ is in the
pool.
Stage 1 :
Submerge the robot in the water and evacuate any air that it
may contain by turning it over.
Stage 2 :
Squeeze the foam pads with your
hands to release the air and to allow water in. It
is essential that the appliance sinks to the bot-
tom of the pool and remains there without aid.
Stage 3 :
Lay out the cable on the pool lea-
ving the fl oat closest to the control unit on the
pool’s edging.
Recommendation:
To make it easier for water to penetrate the foam pads when they are new, run
your appliance in “bottom only” mode for the fi rst six hours (see paragraph “Start-up – Operation”).
Stage 1
Stage 2
5/START-UP – OPERATION
When fi rst switched on, the robot is in standby mode and the display panel will remain unlit.. The
robot is waiting to be programmed or to start.
Prior to using the unit for the fi rst time, the pool’s dimensions and confi guration ,should
be programmed into the unit, in order to optimise the cleaning effi ciency of the Cyber-
naut NT. (This procedure will not have to be completed again).
Representation of keys on the control panel :
Keys:
Start / Stop
Selection of “bottom only” or “bottom and sides” mode
Selection of automatic or remote controlled cleaning
In automatic mode: increase cleaning time;
In remote control mode: move robot forward
Turn robot left (Remote control mode)
Stop robot (Remote control mode)
In automatic mode: reduce cleaning time;
In remote control mode: reverse robot
Turn robot right (Remote control mode).
Display
Indicator lamps:
The robot is operating
in automatic mode
The robot is operating
in remote control mode
The robot is cleaning
the
bottom
and sides
The robot is cleaning
the bottom only
The robot is running.
CYBER NT • ANG.indd 14-15
CYBER NT • ANG.indd 14-15
9/03/06 10:08:47
9/03/06 10:08:47
