/ 9
E
N
G
L
I
S
H
9
DEFLATING / FOLDING THE BOAT
We recommend that you leave the H2P floor in the boat when folding. To clean perfectly the boat
proceed as follow:
- Deflate the boat and the floor; then inflate again the boat a little.
- Wash off with clear water, and then raise the boat’s nose to evacuate water and sand or rubbish.
Acti- V models : do not separate the keel from the floor nor from the buttom.
1. Deflate
the boat (remember to hold the valve insert on the H2P inflatable floor so that it doesn’t fly
off)
and remove the stowage box on Int’l models.
2.
Replace
the valve protections.
3.
Remove
oars and equipment.
4.
Empty
the boat of all water and sand by opening the self-bailers, dry it.
5.
Fold in
the 2 sides of the main buoyancy tube, fold the cones onto the transom (A), then
fold
the boat as show on figure B and C. Start again if you feel there is still some air left in the tubes.
A
B
buoyancy tube floor
tube deflated
2
3
1
1 : floor 2 : anti-skidding fins 3 : transom
C
1 2 3
CAUTION
DO NOT ATTEMPT TO FOLD THE ANTI-SKIDDING FINS,
YOU COULD DETACH THEM FROM THE FLOOR
Stow
the boat in its bag as follows (D):
.
Stow
the boat folded on its bag open (back side of the bag visible).
.
Position
the oars dismantled on top
.
Close
the bag and fasten the two front straps.
.
Tight
the side ropes (make sure that all equipment stays inside).
. To finish,
store the foot-pump in the front pocket.
D
Summary of Contents for CADET 240 AERO
Page 11: ......
