EVAC reserves the right to make alterations to this specification without prior notice.
© Copyright Evac Oy. All rights reserved.
1
EVAC
Commercial Marine Equipment
V
V
V
V
VA
A
A
A
ACUUM
CUUM
CUUM
CUUM
CUUM T
T
T
T
TOILET
OILET
OILET
OILET
OILET
INSTALLATION
Date:
Doc.
25 Jan 2005
2:01015C
5900204
PNEUMATIC PUSH BUTTON
Remove the film out from the cover for protecting pipe.
Put the slide guide tap to the groove on a cover.
Snap the cover with the bellow on to the bottom plate.
Recommended place for the pneumatic push button
! NOTE
: Make sure, that cover does not hit the push button
when opened. If the place is changed, consult EVAC.
Control
mechanism
640
Slide guide
Groove
Pneumatic push button installation
Install the plastic hose to the bellow.
Put the plastic hose on clip behind the bottom plate.
Install the pottom plate on the wall.
53
53
Bellow
Plastic hose
Protecting pipe
Clamp
Protecting pipe installation
Thread the plastic hose through the protecting pipe.
Install the protecting pipe under the discharge pipe.
Install the protecting pipe using installation clamps and
screws.
Protecting pipe
Discharge pipe
Control
mechanism
Bottom plate
Cover
Installation of pneumatic push button in shock tested
toilet
! NOTE:
**Screws are needed only for a shock tested toilet
installation.
! NOTE:
*Holes are drilled when the push
button is installed.
*
Ø4.5
*
20
*
20
*
20
*
20
*
Ø4.5
**
Screws Ø4.2 x 50mm
Push button
