zobelle Z-GR, Manual

Page: 4 / 12

How To Use.
PREPARATION
1. If the hair in the treatment area is more than 2mm long, you should remove it for optimal
results. To do so, shave the area with the razor provided a minimum of
24 hours before treatment.
2. Shave as you would normally and try not to use any new products that you have not yet
tested. We do not recommend dry shaving the area this is to avoid any irritation to the
skin. You do not need to shave the hair in the area if it is not longer than 2mm.
3. Before treatment, you must ensure the skin is hair-free, clean, dry and free from
all lotions, oils, moisturisers, fake tan and other products.
CONDUCT A PATCH TEST
1. Before your first treatment on each new body area, we recommend you test
your skin (in that area) for reactions.
2. The patch test area should be approximately 3 cm x 2 cm in size (equivalent to
2 flashes applied to the skin side by side).
3. Wait 24 hours following the patch test, to ensure your skin is suitable for treatment and
there is no adverse reaction to the light energy. If there is no reaction after 24 hours,
you may treat the area around the test patch. The ‘patch tested area’ should not be re-
treated for at least one week.
HOW TO USE ZOBELLE™ COOLING IPL HAIR REMOVER DEVICE
1. Plug the mains cord into an electrical outlet. Plug the power supply into the power socket.
You will see the device flash 3 times before the screen displays ‘OFF’.
2. To turn the device ‘ON’, press the trigger button (see diagram) and hold for
1.5 seconds. Keep the power cord plugged in throughout your treatment. The device can
be used plugged in and does not need to be charged in advance. The device is not
rechargeable.
3. The default intensity setting on the device is ‘1’ which is the lowest level.
To increase this, short-press the intensity level button (see diagram) to cycle through the
settings and stop on the intensity level you would like to choose.
4. The cooling feature is not on by default. To activate it (optional), short-press the cooling
feature button (see diagram) and you will see the fan icon appear on the screen. To turn
off, press the same button and the icon will disappear.
5. The IPL feature is not on by default. If you would like to activate it, press and
hold the trigger button (see diagram) for 1.5 seconds and you will see the IPL mode icon
appear on the screen. To turn off, press the same button and the
icon will disappear.