ZNYX bh5700, User Manual, Page: 47 / 359

Changing the Shell Prompt
You may use standard bash shell procedures to change the prompts on your base switches. Many
sites choose a system that distinguishes among the individual switches at their location. The same
rules apply for saving your choice (
zsync)
as for all other configuration changes.
Default Configuration Scripts
As shipped the following scripts are run from
/etc/rcZ.d
as the switch boots up:
NOTE: These default scripts will change in later releases. Use them as examples.
S20stack -
Script that calls
zstack
to combine the two BCM56504 24-port switch fabric chips
into a single 48 port virtual switch.
zstack
must be run before any other switch configuration.
S50layer2 -
Script that sets up a basic Layer 2 switch. All 48 ports are set up on one VLAN. This
configuration script is appropriate for a Ethernet Switch Blade. It may need to be modified for
other models.
Example Configuration Scripts
Example scripts are provided that can be used as templates. Use one of the scripts located in the
switch
/etc/rcZ.d/examples
directory to help you configure the switch. The default
configuration for the switch is located in the script file
/etc/rcZ.d/S50layer2
.
The following scripts are included (each is examined in more detail later in the appropriate
section describing common Layer 2 and Layer 3 configurations):
•
S50layer2 -
Script which sets up a basic Layer 2 switch. All 48 ports are set up on one
VLAN. This is a copy of the script in
/etc/rcZ.d
that is loaded in the default
configuration.
•
S50layer3 -
Script which sets up a basic Layer 3 switch. All 48 ports are set up on
individual IP networks (VLANs). Layer 3 switching is enabled.
•
S50multivlan -
Script which sets up multiple untagged VLANs. (See Using the S50layer3
Script) Layer 3 switching is enabled.
•
S55gatedRip1 -
Script which is used with a Layer 3 switch and calls the GateD daemon to
enable RIP 1 routing protocol.
•
S55gatedRip2 -
Script which is used with a Layer 3 switch and calls the GateD daemon to
enable RIP 2 routing protocol.
•
S55gatedOspf -
Script which is used with a Layer 3 switch and calls the GateD daemon to
enable OSPF routing protocol.
Ethernet Switch Blade User's Guide release 3.2.2j page 47