Zmotion VPLC710 Series, Hardware Manual

Page: 32 / 34

VPLC710 Motion Controller Hardware Manual V1.0
Chapter V Maintain & Problem Processing
5.1. Maintain Regularly
Please regularly check the places that are difficult to check during operation. Always
keep the controller in a clean state, effectively remove the dust on the surface of the
product, and prevent the dust from entering the product, especially metal dust.
Check item Check content Inspection standards
Whole machine
Whether there is
accumulation of garbage,
dirt and dust on the
surface.
1. Check whether the power
distribution cabinet is powered off.
2. Vacuum away trash or dust from
touching parts.
3. When the surface dirt cannot be
removed, wipe it with alcohol and
let it dry and evaporate completely.
Cable
Check whether the power
line and connection are
discolored.
Whether the insulation
layer is aged or cracked.
1. Replace cracked cables.
2. Replace damaged connection
terminals.
Outside of
solenoid
connector
Whether the suction is not
firm or makes abnormal
noise during the action.
Whether there is a short
circuit, water pollution,
expansion, rupture of
peripheral devices
1. Replace abnormal components.
Fan channel
port
Whether the air duct and
heat sink are blocked.
Whether the fan is
damaged.
1. Clean the air duct.
2. Change the fan.
Control circuit
Whether the control
components have poor
contact.
1. Clean the foreign objects on the
surface of control lines and
connection terminals.