zlosynth instruments Achordion Build Manual Download Page 4

Page: 4 / 4

Knobs

You can now put knobs on the potentiometers.

1. The silver part of the big knob is protected with a

sticky foil. Peel it off.

2. Put the big knob on the topmost potentiometer.

Use a small flat screwdriver to tighten the screw of

the pot. The screw should be pressing against the

flat part of the shaft. Keep some distance between

the knob and the panel.

3. Put smaller black knobs on the remaining pots.

Align them with the D-shaped shaft and press them

in. You may need to pull them a little bit if you

see they are scratching the nut.

Final assembly

Connect the Daisy Patch Submodule to the main black

PCB to complete the build.

Congratulations

The module is now complete. Have fun!

You can find the user manual on

Figure 7: Side view of the assembled module

Figure 8: Front view of the assembled module

Summary of Contents for Achordion

Page 1: ...The through hole components are left to be assembled by you Pay attention to the orientation and position of all the parts Desoldering them would be difficult and may break the module Also be careful...

Page 2: ...2 Plug the connectors of the submodule into the black PCB through footprints marked as SM Make sure to put them on the correct side of the PCB where all four connectors are marked 3 Solder all the pin...

Page 3: ...el don t be afraid to push them in 7 Tighten all the potentiometers and jack sockets in place with their nuts Take care not to scratch the panel Plastic tools are prefered and steel drivers should als...

Page 4: ...between the knob and the panel 3 Put smaller black knobs on the remaining pots Align them with the D shaped shaft and press them in You may need to pull them a little bit if you see they are scratchin...