zlosynth instruments Achordion Build Manual Download Page 1

Page: 1 / 4

Achordion – Build Manual

Overview

You can always find the latest version of this

build

manual

This kit contains a printed circuit board (PCB) with

all the surface mount device (SMD) parts already pre-

soldered. The through-hole components are left to be

assembled by you.

Pay attention to the orientation and position of all

the parts. Desoldering them would be difficult and

may break the module. Also, be careful not to touch

the pre-soldered SMD parts with the soldering iron.

Read through the whole manual first. Make sure you

understand all the steps before you start soldering.

Tools required

• Soldering iron

• Masking tape

• Small flat head screwdriver

• Side-cutters

Summary of Contents for Achordion

Page 1: ...The through hole components are left to be assembled by you Pay attention to the orientation and position of all the parts Desoldering them would be difficult and may break the module Also be careful...

Page 2: ...2 Plug the connectors of the submodule into the black PCB through footprints marked as SM Make sure to put them on the correct side of the PCB where all four connectors are marked 3 Solder all the pin...

Page 3: ...el don t be afraid to push them in 7 Tighten all the potentiometers and jack sockets in place with their nuts Take care not to scratch the panel Plastic tools are prefered and steel drivers should als...

Page 4: ...between the knob and the panel 3 Put smaller black knobs on the remaining pots Align them with the D shaped shaft and press them in You may need to pull them a little bit if you see they are scratchin...