ProlD Series Water Resistant RFID Access Control Reader
User Manual
P a g e
|
14
Copyright©2023 ZKTECO CO., LTD. All rights reserved.
3
Installation Set-up
ProlD series reader can be installed on the wall alone or mounted to the wall by Asian gang box, single
gang box and mullion mount. The following is an example of wall mounting and Asian gang box installation
of ProlD102. The installation steps are introduced as shown below.
Make sure that the device is installed as per the installation instructions.
Otherwise, you will bear any
consequence resulting from your actions.
3.1
Install on the wall
Step 1:
Attach the mounting template sticker to the wall, and drill holes according to the mounting
paper. The recommended installation height from the ground is 1.5 meters, which can be
adjusted appropriately according to actual needs.
Step 2:
Secure the back plate on the wall with the wall mounting screws.
Step 3:
After passing the wires through the wiring hole and connecting them to the device, and then
attach the device to the back plate from top to bottom.
Step 4:
Fasten the device to the back plate with a security screw.
Figure 3-1
Install the ProlD series reader on the wall
Note:
The installation method of ProlD101 and ProlD103 is the same as that of ProlD102. Only ProlD102 is
used as an example, and will not be repeated here again.
