4
FBL6000 Pro series User Manual
3.
Electric and Civil Installation
1. Device installation conditions
The location where the device is installed must be a concrete flat surface so that the expansion screws
can be fastened firmly. If the planned foundation does not meet this criterion, consult professional
building or decoration personnel and create stable conditions for firmly fastening of the wing gate.
2. Determination of the location of device installation
Decide the installation location based on the space needed as illustrated in Figure 3-1A and Figure 3-
1B.
Figure 3-1A Single-Passage Wing Gate Figure 3-1B Dual-Passage Wing Gate
3. Cable connection
For the location of the hole where the cables come out, please refer to Figure 3-2 below.
4. Device installation
a)
Turn on the master machine and slave machine, adjust the wing arms to ensure that the wing
arms are in the same line and the distance between wings is 50 mm. Turn the wings to the OFF
state.
b)
Test whether the infrared rays transmitted by infrared sensors on both sides align with each other.
c)
Make marks: Mark the screw hole of the base and chassis base edges on the ground.
