To code:
1. First, power the controller of the tripod turnstile.
2. Short press the learning button on the controller, and a light corresponding to the button will flash
slowly. Then press any switch on the remote control for acquiring the information. After the successful
operation, the light turns off.
Clear
c
ode:
Long press the learning button on the three roller gate controller for 3 seconds. The learning light stays on
for a while then turns off indicating the code is cleared successfully. The original learning remote control
cannot be used again and cam only be remote-controlled by the code again.
Please read the
Remote Control of Tripod Turnstile User Manual
to get more information about the two
types of remote controls.
5
Equipment Precautions and Maintenance
5.1
Precautions
1. It is recommended to purchase additional accessories to use the product outdoors.
1) You may install cooling fans for the equipment if the working temperature is often above 50 ºC.
2) The device is rated IP54 waterproof under proper installation. However, its ability to stand in
extreme weather conditions, such as typhoon, is not guaranteed.
3) If the temperature is around or below -30
º
C, you are recommended to install a heating plate for
the equipment. You might need to turn the power on multiple times to let the device
automatically heat up through the self-check program.
4) The service life of this equipment may be shortened if it works outdoors in coastal areas or a
region prone to acid rain.
2. If the power and signal cables are connected properly, this equipment can be immersed under water
at a depth of 250 mm, but it must not be powered on when it is immersed in water.
3. It is highly recommended to set a warning card-swiping line to remind passers-by to correctly swipe
cards at a reasonable distance from the device to prevent passers-by from being squeezed.
4. It is recommended to place a warning sign at a conspicuous position, and prompt: "
Please swipe
your card outside the warning line and pass in order. Thank you!
”
The maximum stress tolerance of the tripod turnstile's arms
Please note that the maximum tolerance at the center and the ends of the arm is 80kg and 40kg,
respectively (See Figure 5-1). When the impact force on the tripod turnstile reaches the designed limit, the
arms will break down first to ensure that the body of the equipment is not damaged and the passer-by is
not injured.
