http://www.zketech.com
EBD-A20H User Manual
Copyright (C) 2006-2017 ZKETECH
0000mAh, 00.00Ah and 000.0Ah). Press the
“
ON
”
button to start discharging and press one
more time to stop working.
A short press on the
“
SET
”
knob can switch between power (W) and capacity.
In the halted state press
“
SET
”
knob for two seconds or longer to open the setting interface
(this function disabled when the tester connects to a computer).
4.3 Setting interface
The first line shows testing mode and discharging current. (Discharging current turns
discharging power in CP mode).
The second line shows cut-off voltage (testing stops automatically when voltage reaches below
the set parameter) and the testing time (0-999 minutes, no limitation when it
’
s set 0).
The cursor sets automatically on the testing mode and you can move it to the option you want
to change. One press on the
“
SET
”
knob to move one step to right. Rotate
“
SET
”
to left and
right to change the parameter. The parameter will change automatically if it exceeds limitation.
Press the
“
ON
”
button to switch to next setting option.
After completes settings, press
“
SET
”
knob for a long time to save data and return to the
upper-level interface. In the testing interface press the
“
ON
”
button to start testing.
4.4 Setting examples
1) Setting steps
Ø
Turn on the battery tester.
Ø
Connect battery and you can read the battery voltage on the testing interface on the
screen.
Ø
Press
“
SET
”
knob for more than two seconds to open the setting interface.
Ø
Set testing parameters.
Ø
Press
“
SET
”
knob for more than two seconds to return to testing interface.
Ø
Press
“
ON
”
button to start testing.
Ø
When testing completes rotate the knob to left and right to read test results.
Ø
Remove the battery and turn off the tester.
2) Discharging 3.7V LiPo to 2.8V at 10A
