In bin-picking applications
For bin-picking applications, place the Zivid camera projector above the back edge
or above the rear corner of the bin (see images below). Pan and tilt it so that the 2D
camera is looking at the bin center. The projector rays should not fall on the inner
surfaces of the two walls closest to the projector; they should almost be parallel to
those two walls. Mounting the camera this way minimizes interreflections from the
bin walls.
Cooling clearance
Zivid cameras use active and passive cooling, allow some space around the device
for airflow, and do not block the air opening on its front and rear sides. Advise the
technical specifications for the operating temperature range for your camera.
Signal protection
Do not install Zivid cameras and cables next to high voltage devices that can generate
high levels of electromagnetic disturbance. Do not route camera cabling through
the same trunks/conduits with AC power cables and cables emitting high levels of
disturbance.
Rev 1.3 - 11/2021
11
Zivid.com
