Zipro Notus, User Manual, Page: 31 / 121

31
EN
FOLDING AND UNFOLDING
PLEASE NOTE! Before you start folding, check if all the bolts are tight and disconnect the power supply
cable.
Folding the device
Lift the running belt of the device to the horizontal
position until the lock clicks.
Unfolding the device
Hold the running belt and release the folding lock
(indicated with the arrow). Lower the belt to the
railing level.
The belt will now descend automatically.
PLEASE NOTE! Ensure there are no third party or
animals in the immediate treadmill vicinity
when its belt is lowered.
BELT TENSION ADJUSTMENT
WHEN SHOULD I INCREASE BELT TENSION?
As a result of regular use, the running belt may require tensioning.

A too loose belt may stop despite a running motor.

Do not overtension the belt as it may damage the motor, shaft, or bearings.
 A correctly stretched belt can be lifted on the sides up to about 5–7.5 cm. It is easily verifiable.
The belt is tensioned correctly if you can fit three fingers under it.
The belt needs to be tensioned when it starts to slip, slide sideways, or curl during training.
Place the treadmill on a flat surface. Run the treadmill at about 6–8 km/h and note the deviation of the
running belt.
INCREASING BELT TENSION
A special wrench was included in the delivery. Place it in the left belt adjustment bolt in the rear of the
treadmill. Rotate the wrench 90 degrees clockwise (Fig. C). This way, you stretch the rear roller and increase
belt tension. Repeat for the right bolt. Make sure the bolts are tightened equally.
Repeat on both sides until the belt tension is correct.
REDUCING BELT TENSION
Belt tension is reduced in a similar way to how it is increased. Rotate the wrench counterclockwise.