24
Your Zipr Breeze requires two sealed, maintenance free 12-volt, 32 AH batteries.
Charge the batteries prior to using your scooter for the first time.
Keeping the batteries fully charged will keep your scooter running well.
READING YOUR BATTERY VOLTAGE
The battery condition meter on the tiller console indicates the approximate
strength of your batteries using a color code. See figure 8. Green indicates fully
charged batteries, yellow indicates a draining charge, and red indicates that an
immediate recharge is necessary. To check the charge, you must first unplug
the charger power cord and power up your scooter. To ensure the highest
accuracy, the battery condition meter should be checked while operating your
scooter at full speed on a dry, level surface.
You can also check the charge using the ammeter located on the rear of the
scooter. The charger power cord must be plugged into a standard wall outlet in
order to obtain a reading. When the amperage reading is at or near zero amps,
the battery charging is complete. See figure 9.
FIGURE 8. BATTERY
FIGURE 9. AMMETER
CONDITION METER
CHARGING YOUR BATTERIES
Follow these easy steps to charge your batteries safely:
1. Position your scooter close to a standard wall outlet.
2. Remove the key from the key switch.
3. Make certain the manual freewheel lever is in the drive (up) position.
4. Plug the charger power cord into the charger power cord receptacle.
5. Extend the charger power cord and plug it into the wall outlet. It is
recommended that you charge your batteries for 8-14 hours.
6. When the batteries are fully charged, unplug the charger power cord from
the wall outlet and then from the charger power cord receptacle.
BATTERIES & CHARGING