20
Secure the keel shoe with the 3 brass flat head
screws.
Remove the shoe and apply sealer to all sides.
Motor
Slip the motor in place from the front and secure
with the 2 M3x8 screws and washers.
Run the motor wires to the starboard side of the
hull.
Prop Shaft
The prop shaft is 1/8 stainless steel, and the
plastic prop simply pushes on the end.
Don’t worry about the prop slipping. There is not
enough torque to make it slip.
Clean the prop shaft with any solvent as it is
manufactured with a protective coating.
Assemble the motor coupler. This is a piece of
clear plastic tubing with 2 metal collars.
Slip a collar on each end of the clear tube.
Make them about 1/8 inch from the ends.
Put in the set screws but do not tighten.
Summary of Contents for Tugster
Page 25: ...25...
