MK-100301 EU_EN_Rev. 6.0 - US Rev. F
14
ENGLISH
ENGLISH
VII. WARNINGS– COMPONENTS & OPTIONS
14
D. FOOTREST
WARNING
1. Adjustment of the footrest may cause interference with
the front lower frame in some positions. This interference
can affect the comfort and proper support for the seated
dependent.
2. Avoid putting extra weight on the footrest. The mobility device
may tip forward (or backward if seating system has been
reversed).
3. Never lift this mobility device by the footrests.
4. Do not stand on the footplate during transfer. The chair is likely
to tip to the front when standing on the footplate.
5. Always place your feet securely on the ground for transferring
into or out of the chair.
E. TYRES AND WHEELS
WARNING
1. Yearly tire inspection for excessive wear is suggested to
ensure good traction in all types of environments.
2. When installing front or rear wheel/tire assembly, slide the
wheels into the axle opening until the quick release button pops
out, and you hear a click. Your wheel is now fully engaged and
locked.
3. In case of tyre damage contact your health care professional to
get a replacement.
A. BASE FRAME
WARNING
Inspect cables and engage/release buttons before every use to
make sure they are in good working condition. Be sure that
your base frame is locked before seating your child.
B. UPPER EXTREMITY SUPPORT TRAY
WARNING
Before adding or removing a tray to the mobility device be
sure to point front casters to the front of the device and
engage parking brake. This keeps the wheels from rolling
when attaching the tray. The support tray has a weight
capacity of 23 kg, (50 lbs).
1. Do not lift this product by its tray support arms.
2. ALWAYS make certain that the tray is fully locked into place
after adding it to the dependent mobility device.
C. FASTENERS
WARNING
Many of the screws, and nuts on this product are considered
to be special high-strength fasteners. They require periodic
checks and maintenence to ensure the safety of both the user
and attendant.
1. Most adjustments that require removing hardware should be
done by your Service provider.
2. Only use fasteners provided by an authorized supplier (or
ones of the same type and strength), as indicated by the
markings on the heads.
3. Do not over- or under-tighten fasteners. If screws or nuts
become loose, tighten them as soon as possible.
