OPERATION
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite25
Rolltischsäge / Roll table saw ZI-RTS700
14
OPERATION
A T T E N T I O N
It is strictly prohibited
to
dismantle
the
protective
devices
located on the
machine, modify or alienate purpose or to bring in external protection devices.
Retrofitting, servicing and maintenance work that can be undertaken only with
dismantling of protective devices are permitted only if before the power supply is
safely interrupted by pulling the power plug.
14.1
Operation
14.1.1
Start / Stopp
Start the engine, if you have the rolling table saw mounted correctly:
The engine is started using the green button on and off with the red button or close the
EMERGENCY-hatch by the switch unit (
9
).
Important:
Let's start the machine until complete to the maximum speed before you begin
sawing be.
14.1.2
Saw
Position the clippings on the fully extended rolling table.
Turn on the machine.
Press so press the retaining claws (8) firmly on the work piece with the right hand the handle
(7) downwards.
Move the sliding table to the rear.
By retaining claws protected the workpiece against rotation.
The right hand can be relieved by pushing the table with the thigh. After the sawing of the ball bearing table
slides through the balancer back to the initial position.
After cutting, move the sliding table back completely.
Turn off the machine after work.
Wait until the machine stands still again.
If an automatic return pressure of the table no longer occurs because the spring is worn out or
defective, the cut with the machine must be avoided until the repair or replacement of the
spring.
Do not forget to hook the table backup again after work!
15
MAINTENANCE, CARE AND STORAGE
15.1
Blade change
The prescribed
blade for Roll table saw
has the following data:
Diameter: 700 mm, Bore: 30 mm, thickness: 3.2 mm, tooth shape: flat tooth saw HM