MAINTENANCE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Seite 24
BETONGLÄTTER / POWER TROWEL ZI-MOS145G
ite 24
15
MAINTENANCE
Checks and activities to be performed
Check fuel level
Always before operation
Loose or lost screws and nuts
Always before operation
Damage of any machine part
Always before operation
Check for Petrol or oil patch/spot under
the machine. Check petrol pipe, fuel tank
and fuel tank cap for leaks.
Always before operation
Check motor oil level / fill-up if necessary
Always before operation
Clean machine and rotor blades
Always after operration
Belt tension
Always before operation
Belt condition
Always before operation
Lubricate rotor blades at lubr. nipples
every 20 working hour / weekly
Clean air filter
every 100 working hour/ monthly
Check spark plug/ event. clean
every 50 working hour/ weekly
CHANGE motor oil (
SAE 10W40)
20 working hours after 1st operation
/every 200 working hours
Gear oil
every 100 working hours
15.1
Change motor oil
Best performed 20 minutes after operation.
Place oil pan under drain screw
Loosen and remove drain screw
Let motor oil drain completely – dispose environmentally
compatible!!!
Fill in new motor oil into the oil filler plug up to lower
edge of filler.
Tighten the plug firmly.
15.2
Clean Air Filter
A polluted air filter causes problems when starting the combustion engine, it leads to loss of
power output and to engine failure.
A air filter not maintained properly reduces your engine`s lifespan dramatically. ZIPPER
MAschinen can not be hold liable for warranty claims due to engine defects caused by
insufficient air filter maintenance.
In order to clean the air filter loosen and remove first the wing screw oft he air filter cover.
Remove the air filter cover and take out the air filter.
Clean the air filter parts mechanically!
Wipe the surface off with a solvent consisted of three parts Diesel and one part motor oil.
Drop motor oil onto the air filter, excess motor oil shall be removed from the air filter by
wringing it out.
