Zipper Mowers ZI-ASA550, Operation Manual

Page: 27 / 52

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  27
ZI-MOS145G i 27
N O T I C E
Use only permitted extension cable with cross-section
the one in the following table declared.
Voltage Extension Cross-section
220 V-240 V
50 Hz
<27 m 1,5 mm 2
<44 m 2,5 mm 2
<70 m 4,0 mm 2
<105 m 6,0 mm 2
12.4 Assembly (Fig. 1/3/4/5)
Important! Pull out the power plug before carrying out any maintenance, resetting or
assembly work on the vacuum extraction system!
• Screw the side panels (2) together with the chassis frame and the plastic housing (1) in such a
way that the opening for the debris bags is above the base plate (15).
• Insert the holding device (11) for the dust bag into the intended location hole (16) on the upper
side of the plastic housing (1). Do this is such a way that the hook is located above the opening.
• Securely fasten the lower debris bag (7) to the underside of the opening by means of the quick
clamp device (9)
• Securely fasten the upper debris bag (8) to the upperside of the opening by means of the quick
clamp device (10) and hang it on the hook of the holding device (11).
• Connect the extractor hose (6) to the adapter (14) and attach it to the socket on the vacuum
extraction system.
13 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1 Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
H I N W E I S
 Place the machine next to the woodworking machine in a way that it will
not interfere with your work!
 Start to work with the woodworking machine only until the dust collector
has reached full speed!