ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
23
ZI-HS8TN
3.
Assemble control lever
Pull the spring pin (A) to remove the
locking pin (B). Apply a thin layer of grease
to both surfaces of the operating lever
guard (see figure). Insert the control lever
and guard and make sure that the end of
the control lever fits into the slot of the
connecting bracket (C). Lock the control
lever and the guard with the locking pin (B)
and the spring pin (A) downwards. Follow
the same steps to mount the control lever
and the guard on the other side
N O T I C E
Check both sides after assembly. The
operating levers must be inserted in
the slots of the connection brackets.
4.
Assemble adjustable log holder
Align the holes and assemble holder 1 and
holder 2 on the log clamps. Pay attention to
the direction of the holders as shown in the
following figure. Secure the joint with
M6x16 screws, washers
and nuts. Secure the log clamps on the arm
guards with star knobs and flat washers