25 |
P a g e
ADDING DEVICES
Adding new devices Z-wave or ZigBee
Before adding new device some preparation is needed to
ensure successful connection to Zipabox. First
insert
batteries
to device or connect it to the power supply. It is
recommended to bring device closer to Zipabox so no
obstacle can interfere with operating range of device.
Recommended
distance between sensor
and Zipabox
should be
less than one meter
Read device instruction
regarding inclusion/join mode. Device in inclusion/join mode is
awake and ready for joining in to Zipato network. In case that
device has already been used and connected to controller,
reset device
. Reset deletes any information about prior
controller that was stored in device.
At the end of joining or removing session it is recommended
to
refresh
Zipato Control Center
or wait until number of
device isn’t increased by one to make sure that device is
visible in Total device list.
