3
INSTALLATION INSTRUCTIONS & USER MANUAL
210006 V2.00 SEPT 2017 - ZIP VPII/103-153(UB)
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
These instructions will guide you through the installation, maintenance and use of the Zip
Varipoint II, however, if you require any further information please call Zip customer service
on 0345 6 005 005.
• The Zip Varipoint II is an unvented water heater designed for connection directly to
incoming mains water supply and can serve one or more outlets using conventional
taps.
• Care should be taken that the unit being chosen can meet the demands of the outlets
being supplied.
• The casing is constructed of impact resistant plastic and heat losses are minimised by
the high efficiency polyurethane foam insulation.
• The inner vessel is constructed from heavy gauge copper and pressure tested to 1.6
MPa (16 bar), maximum working pressure 0.55 MPa (5.5 bar).
• A manually resettable safety cut out automatically cuts off the electrical supply to the
heating element in the event of a malfunction.
If the hot water system is not used for two weeks or more, it is recommended that a
hot tap be turned on for several minutes at a sink, basin or bath, it is not recommended
that either a dishwasher, clothes washer or other appliance be used before the heater
is returned to service.
The Varipoint II models are approved to the LVD and EMC directives and CE endorsed.
The Varipoint II models have been examined, tested and found when correctly fitted to comply
with the requirements of the United Kingdom Water Regulations / Byelaws (Scotland). The
products are listed under the WRAS (Water Regulations Advisory Scheme) Water Fittings and
Materials Directory.
GENERAL PRODUCT DESCRIPTION
APPROVALS