10
Installation instructions & user manual
9120-25693 v3.00 Oct 2018 - ZIP CEX
Technical support
Tel: 0345 6 005 005 email: [email protected] www.zipwater.co.uk
INSTALLATION
• Attach the water connection pipes to the
appliance’s water connection. Use the
½ inch seals.
• Open and close the hot water tap until no
more air emerges from the pipe and all air
has been eliminated from the water heater.
Mounting the appliance
Installing the appliance
263
179
140
41
84
26
140
7
7
96
28
37
26
Fig. 1
Fig. 2
Fig. 3
• Thoroughly flush the water supply pipes
before installation to remove soiling.
• Hold the appliance on the wall, and mark
the drill lines at top and bottom, right and
left, corresponding to the small notches at
the edge of the appliance front cover (see
figure 1). The alignment template (located
on the pull-out pages in the middle of this
manual) may be used for this purpose.
• Connect the top and bottom marks
vertically with each other (A–A).
• Connect the right and left marks
horizontally with each other (B–B).
• The intersections of these lines are the
drill points (see figure 2).
• Drill the holes using a 6 mm drill. Insert
the included dowels and screws. The
screws have to protrude 5 mm.
• Hang up the appliance into the rear
hanging openings until it clicks into place
(see figure 3).
