Page 6 of 12
Installation & Operating Instructions - 87078 - May 2012 v1.01
Normal Operation
Set Time
To change time, press either Mode > or Mode
<
button until Set Time is on the display screen. Press > Adjust button
to increase time or
<
Adjust button to decrease time. Time increases or decrease in increments of one minute. Hold the
Adjust buttons down for rapid increases or decreases. The time will be displayed in 24Hr mode.
Set Day
Press either Mode > or Mode
<
button until Set Day is displayed.
Press > Adjust or
<
Adjust to select day.
Filter Life
( factory set at 6000 Ltrs )
Press either Mode > or Mode
<
button until Filter Life is displayed.
Press > Adjust button to increase Filter Life or
<
Adjust button to decrease Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.
Press > Adjust and “Filter disabled “ will appear - Note: This functions not applicable for these appliances.
Reset Litres Filtered and months used
This function is to reset the Filter Change display after a filter has reached the end of its life (refer to “Replace Filter
Instructions” section of this document).
Press either Mode > or Mode
<
button until “Litres Filtered” is displayed. Press > Adjust once and “Reset Counter”
will be displayed, press > Adjust button once and “Are You Sure” will be displayed.
Press > Adjust once and “Don’t forget to flush the filter” will appear. The “Litres Filtered” will be reset to 0.
Activating Sleep Mode
This mode allows the Hydroboil Duo to go into Energy Saving mode. In this mode the unit will go to “sleep” after a
pre-determined period of inactivity. Press either Mode > or Mode
<
button until “Sleep Mode” is displayed. Press
> Adjust once to select 2 Hours or twice to select 4 Hours. When the period of inactivity passes, the display will show
“Sleep Mode”.
To de-activate the sleep mode, press any button on the display or drain sufficient hot water to energise the system (i.e.
Normal operation) and then allow sufficient time for the water to reach the set temperature.
Activating On / Off Mode
Press the Mode > or Mode
<
button until “Monday On” is displayed. To set the time for the unit to turn on press >
Adjust button until required time is reached.
To set the time for the unit to turn Off press Mode > button once and “Monday Off” will be displayed. Now press >
Adjust until required time is reached.
If each individual day is to have an “On / Off” time, these steps need to be repeated for each day and for each On / Off
time.
To de-activate the Off mode, press any button and drain sufficient hot water to energise the system (i.e. Normal opera-
tion) and then allow sufficient time for the water to reach the set temperature.
Setting the energy saver timer
Mode plus button
Mode minus button
Plus adjust button
Minus adjust button
