12
Unpacking
Remove the carton and check the sandblasting cabinet for damage, defect parts etc.. In case of
damage through transport or defect parts, immediately contact your Zionair-retailer.
Assembly
1.
Mount the gloves (23, fig.1) onto the rings with the clamps (24, fig.1).
2.
Place the lamp (15, fig.2) in in the clamp (14, fig.2) and secure.
3.
Connect the air hose (32, fig.3) to the hose connector (33, fig.3) of the air inlet and secure
with the hose clamp.
4.
Operation
Preparation
1.
Before you can start sandblasting make sure the workpiece is free of oil, water and moisture,
make sure the workpiece is dry and clean.
2.
Set the work pressure of the compressed air between 4 and 8.6 bar, 8.6 bar is the maximum
work pressure, grit breaks down faster with a higher work pressure. ADVICE: Start with a
working pressure of 4 bar, most work pieces can be blasted easily with this pressure. For
light steel, aluminum and other fine work pieces you can better start at a low working
pressure and if necessary adjust the pressure higher for the optimal result.
3.
The blasting grit should be of good quality, but it is probably even more important than it to
be moist free. Moist grit clutters, which causes a bad flow and clogging.
Summary of Contents for SB19A
Page 5: ...4 3 Assemblage...
Page 12: ...11 3 Assembly...
