14
#165 5825
234
(7)
If all the operation is normal, the POWER, SOURCE LED will glow solid blue and Signal Strength
will light in blue with 3 signal strength. Please refer the next LED details part:
Note:
(1)
Make sure your multiple High-Definition devices connected with ZWD-2500T have already
powered on.
(2)
Warming-up or source switching time should be approximately 15~20 seconds during the
normal operation.
(3)
ZWD2500 remote control will not control your A/V components’ operation.
(4)
Video from the YPbPr component source device appears but dim, press the
3/4 YPbPr
button
repeatedly on the remote control to fine-tune the picture performance.
TRANSMITTER/RECEIVER LED indicator light details:
LED indicator status light on the front that indicates what’s happening..
Note:
(1)
The Strength LED indicator shows whether a connection is active with the transmitter side.
During the normal operation, the Strength LED indicator will light in blue with 3 signal strength.
If there is no signal strength and blinking blue in Source & Status LED, the transmitter are most
likely out of range. You may verify the range and adjust the distance closer between transmitter
and your HDTV set with receiver. (The maximum video transmission range is 20 meters at line
of sight (LOS) scenarios and 10 meters beyond line of sight.)
POWER
LED
Source LED
Mode
Status
Solid Red
Off
Standby
In standby mode
Solid Red
Off
HDMI
connection
in Hot Plug
status.
TV & Receiver are both powered on, and then
remove HDMI cable connection from receiver.
After 1 minute, the receiver will automatically enter
the standby mode which POWER LED stops
blinking and turns solid red.
Blinking Blue
Blinking
In wireless
Linking
Warning up in progress or interrupted RF
connection.
Blinking 3 times
per second
(Quickly)
Input from selected source device is not detected.
Blinking 1 times
per second
(Slowly)
Unrecognized video format.
(Not support or out of range.)
Solid Blue
Solid blue
On Mode
Recognized video format.