BEFORE YOU START
6
HOW TO RIDE
Warning: There is risk of falling down
whilst riding, so make sure to wear
helmet and protection kits all the time.
1. Turn on the scooter via the switch under the footplate.
2. Put one foot on the Deck Sensor and kick off with the other foot. The E4 Spaceman
is kick motion activated.
3. You will need to press the deck sensor continuously for the motor to engage.
4. Once in motion, the motor propels the E4 Spaceman up to 5mph/8kph.
5. To stop - release the deck sensor and press the rear foot brake until stopped then step
off your scooter.
6. Turn off the scooter via the switch under the footplate.
Deck Sensor
On / Off switch
NEED HELP?
Visit our website for replacement parts and product support
WWW.ZINCSPORTS.COM
or call our customer service line on
+
44
(
0
)
800 731 0006
Adult assembly required.
Allow at least 3 hours for initial charge. By not doing so you will invalidate the warranty.
WARNING!
Before assembling the scooter, please check whether the power switch is in the “OFF” position, if not,
please put it in the “OFF” position before continuing with assembly.
ASSEMBLY:
HEIGHT ADJUSTMENT:
- Assembly can typically be completed in up to 5 minutes, not including the initial charge time.
- Charging time is at least 3 hours for the first time.
Before you first experience your scooter, please read the USER MANUAL thoroughly and learn the basics to
ensure your safety and the safety of others.
Failure to follow the basic instructions and safety precautions listed in the USER MANUAL, can lead to damage to your scooter, other property damage,
serious bodily injury, and even death.
WARNING
Remove the top plate with the allen key provided.
Centrally align the handlebar grips across the stem.
Replace the top part of the clamp, ensuring it locks
together at point ‘A’.
Firmly tighten the top nut with the allen key.
2. Handlebar Assembly
Release lever (1). Pull up (2) to release and unfold (3)
until the locking mechanism locks into the slot.
Hand tighten the nut on the opposite side of the
quick release lever. Close the quick release lever (4).
(The degree of tension of the quick release lever will
depend on how tight the nut is. Be careful not to
have the lever too loose as this may cause issues.)
1. To unfold the E4 Scooter
Release lever (1). Pull up (2) to release and fold (3).
Hand tighten the nut on the opposite side of the
quick release lever. Close the quick release lever (4).
3. To fold the E4 Scooter
How to adjust the height of the stem.
Push button in, and pull up
handles until they
reach desired height.
Top bolt
Point ‘A’.
Lock the 2 halves
together before
tightening the top bolt.
1. Open
lever
4. Close
lever
2. Pull release
3. Fully open
2. Pull release
3. Pull closed
1. Release lever
4. Close lever
Push the clamp closed.
Reverse the process when
folding your scooter down
for storage.
Pull open Clamp