Zimmer Biomet Zfx EvolutionNEXT, Manual

Page: 31 / 66

31
NOTE
The scanning procedure is identical to scan data gathering → Chapter 4.5 “Operating mode – Scan” /
→ Chapter 6 “Scanning process”
×
Align additionally gathered data with the basic data set using the post processing “Align mesh” function (
→
Chapter 4. 5. 9).
PLEASE NOTE
Additional scan objects cannot be renamed or deleted; it is only possible to delete the content of the scan (3D data)
and not the scanning step.
4.5.8 Selecting and deleting a data set
When a scan step has been completed, the user can select and delete unnecessary data. This function is available in all
operating modes (Configuration / Scan / Post Processing).
NOTE
Selecting and deleting 3D data affects the amount of data to be stored. The less there is, the smaller
the space required on the storage medium.
Selection and deletion procedure
The area to be scanned is already limited by the scan area setting ( → Chapter 4.5.3) and the tooth selection ( → Chapter 4.5.4).
In order to select and delete redundant data, the previously scanned step must be selected in the Scan Assistant.
NOTE
It is recommended that the 3D data view be positioned using the options described in → Chapter 3.4.2.
The background color (green blue) in the Scan Assistant shows whether scan data
have already been gathered (
→
Chapter 4.5.2).
Before Choice of selection After
Uncut 3D data set
Residual data are shown as gray areas.
e.g. drag out a rectangular frame
using
SHIFT + LMB in order to select
unwanted data
The different selection options are
described in
→ Chapter 3.4.3 “Selection of
3D data”.
Redundant data are deleted.