ZIMM ZA-25, Instruction Manual

Page: 34 / 37

ZIMM Actuator 8 Decommissioning and recommissioning
36 Version 0.6 2023
8 Decommissioning and recommissioning
Decommissioning
Recommissioning
After the ZIMM Actuator has been out of use for a long period:
1. Drive through the full working stroke.
2. After initial lubrication, lubricate lubrication points according to the table.
See point 7.2.3 page 26 for trapezoidal screw drive.
See point 7.2.4 page 28 for ball screw drive.
9 Repair and replacement
NOTE
The warranty becomes void if the ZIMM Actuator is dismantled.

Allow the ZIMM Actuator to be dismantled only by ZIMM or by
personnel authorised by ZIMM.

Contact ZIMM GmbH.
10 Disposal
The ZIMM Actuator satisfies the current standards and regulations for
disposal of end of life equipment. It contains no poisonous substances
which demand the taking of special precautions.

During disposal, ensure:
– Compliance with regional laws and regulations for waste
disposal
– Correct disposal and recycling should be entrusted to a
professional disposal company
The following materials will require disposal:
• Lubricants (grease or oil in the gearbox, lubricating grease on the
spindle)
• Steel parts (coated with environmentally-friendly paints or coatings)
• Anodised aluminium (parts)
• Bronze/copper (bevel gear, nuts or windings on the motor)
• Plastic parts (seals etc.)
CAUTION
Corrosion!
Damage to the ZIMM Actuator after a long period out of use.

Oil shiny points.