Getting Started with Zilog’s ZMOTION
TM
Development Kit
UM022801-0610
11 of 18
Connecting the USB Smart Cable to the Development Board
Caution:
The power to the development board must be disconnected or turned OFF
before connecting or disconnecting the USB Smart Cable.
Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable six-pin DBG
connector (see figure below). Attach the free end of the ribbon cable to the DBG connector (ZDI
Interface) on the development board. Ensure that pin 1 on the ribbon cable (indicated by the dark
stripe) is aligned with pin 1 on the target connector (indicated by a square solder on the DBG pin).
Connecting the Six-Conductor Ribbon Cable to the USB Smart Cable
