Z8FMC16100 Series Motor Control Development Kit
Quick Start Guide
QS002810-0111
Page 8 of 12
Do not connect the power supply to the development board before con-
necting the Z8 Encore! XP®Smart Cable to both the host PC and devel-
opment board.
Observe the following steps to connect Serial Smart Cable to the Development Board.
1. Connect the serial port of the PC to the Z8 Encore! XP Smart Cable DB-9 female con-
nector.
2. Connect the Z8 Encore! XP Smart Cable to development board pin header P2.
Connecting Power to the Development Board
Connect the power supply to the development board at Jumper J1, then to an electrical
outlet.
Getting Started Using ZDS II
Observe the following steps to open and use the
ledBlink.proj
sample project.
The following procedure references the
ledBlink.zdsproj
file, which
is located in the following filepath:
C:\Program Files\Zilog\ZDSII_Z8Encore_<version_number>
\samples\Product grouping\Z8xxxx_ledBlink\src
where
<version_number>
refers to your version of ZDS II and
Z8xxxx
is the CPU family.
To provide examples, for ZDS II v4.10.1 and lower:
C:\Program Files\ZiLOG\ZDSII_Z8Encore!_4.10.1\
samples\Z8F642x_ledBlink\src
And for ZDS II v4.11.0 and later:
C:\Program Files\ZiLOG\ZDSII_Z8Encore_4.11.0\
samples\XP_F64XX\XP_F64XX_ledBlink\src
Caution:
Note: