12 of 57
HXL-8844Plus HDMI Matrix Switch User Manual
UM-004-0001-000-01 |
August 29, 2020
© 2020 Zigen Corporation
www.zigencorp.com
H
X
L
-P
lu
s
U
se
r
M
a
nu
al
IR Input Connection
The IR Input Plug can be connected to an IR Receiver (3-pin Jack, 5V) or 3rd party Control Systems (2-pin
Jack). The pin out for the IR connectors are as follows:
Refer to section
Infrared (IR) Protocol
for a list of available IR commands the protocol used to command
the HXL-Plus.
RS-232 Connection
An RS-232 connection is typically connected to a 3rd party Control System to configure the HXL-Plus.
Communication through the RS-232 power is enabled in both Active and Standby Modes.
The default settings are:
Baud Rate: 115,200
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: None
For information on the RS-232 control protocol, refer to section
RS-232 Control
.
Ethernet LAN Port
The Ethernet LAN port is a 100 Base-T connection to any router, switch, or directly to a computer. The
HXL-Plus features a web interface, called ZigNet. Hardware configuration, EDID management, and
advanced diagnostics can all be accessed through ZigNet.
The Ethernet LAN also feature HTTP or Curl protocol to allow 3
rd
party Control Systems with appropriate
drivers to control the HXL-Plus. Refer to section
Application Program Interface (API)
for more
information.
Power
Use the included power adaptor and ensure the locking ring is threaded snugly to prevent inadvertent
disconnection of the power jack. Make sure all video, audio, and control ports are properly connected
before applying power to the HXL-Plus.
Included Power Supply:
HXL-88Plus: 24VDC @ 5.0 Amps
HXL-44Plus: 24VDC @ 2.71 Amps
GND (5)
TX (2)
RX (3)
8
9
10
Rear Panel
7
IR INPUT (2 or 3 pin support)
IR In
+5VDC
GND
IR In
GND