2
When a Scenario Button is pressed, the Scenario Switch will send a signal to the Control Panel to activate the
correspondent scenario (see Control Panel for details). The switch will also emit a beep as indication.
ZigBee Network Setup
ZigBee Device Guideline
ZigBee is a wireless communication protocol that is reliable and has low power consumption and high
transmission efficiency. Based on IEEE802.15.4 standard, ZigBee allows a large amount of devices to be
included in a network and coordinated for data exchange and signal transmission.
Due to the fundamental structure of ZigBee network, ZigBee device will actively seek and join network after
powering on. Since performing a task in connecting network may consume some power, it is required to follow
the instructions to avoid draining battery of a ZigBee device.
- Ensure your ZigBee network router or coordinator is powered on before inserting battery into ZigBee device.
- Ensure the ZigBee network router or coordinator is powered on and within range while a ZigBee device is in
use.
- Do not remove a ZigBee device from the ZigBee network router or coordinator without removing the battery
from a ZigBee device.
Joining the ZigBee Network
As a ZigBee device, the Scenario Switch needs to join a ZigBee network to connect to the ZigBee devices.
Please follow the steps bellow to join the Scenario Switch into the ZigBee network.
1. Remove the cover by using a screwdriver.
2. Insert the battery then replace the cover.
3. Press and hold the Function Button for 10 seconds and release when the Red LED flashes once to join
ZigBee network. Please make sure to enable the permit-join feature on the router or coordinator of your
ZigBee network.
4. If the Scenario Switch successfully joins a ZigBee network, the Red LED Indicator will flash twice to
confirm.
5. After joining the ZigBee network, the Scenario Switch will be registered in the network automatically. Please
check the ZigBee network coordinator, system control panel or CIE (Control and Indicating Equipment) to
confirm if joining and registration is successful.
Removing Device from ZigBee Network (Factory Reset)
To remove the Scenario Switch from current ZigBee network, the switch must be put to Factory Reset to
complete device removal. Factory Reset function will clear the d of its stored setting information and prompt
the Scenario Switch to search for new ZigBee network.
Before removing device, make sure the Scenario Switch is within current ZigBee network signal range
1. Press and hold the function button for 10 seconds, then release the button to reset Scenario Switch.
2. Upon reset, the Scenario Switch will clear current ZigBee network setting and transmit signal to ZigBee
coordinator to remove itself from current ZigBee network. It will then actively search for available ZigBee
network again and join the network automatically.
Installation
The Scenario Switch is designed to be mounted on a flat surface with fixing screws.
The base has 3 knockouts, where the plastic is thinner, for mounting purpose.
1. Remove the cover by using a screwdriver.
2. Break through the appropriate knockouts on the base.
3. Using the holes as a template, drill holes in the surface.
4. Screw the base into the surface.
5. Replace the cover back onto the base and secure it by tightening the fixing screw.
