ZigBee Wireless CCT Remote
70100003
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Back side
Click to turn on the paired
lighting devices
Click to turn off the paired
lighting devices
Press and hold down to search and pair to ZigBee network
or factory reset the dimmer switch
Brightness button, press
and hold down to
increase/decrease light
intensity
CCT color button, press
and hold down to adjust
color temperature
Note: This switch
supports 1 group for
binding max. 30 lighting
devices.
•
This device contains a button lithium battery that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Safety & Warnings
Protocol
Operation Voltage
Transmission Frequency
Transmission Range (free field)
Protection Type
Dimming Range
Dimensions
ZigBee 3.0
3VDC (CR2450)
2.4GHz
30m
IP20
0.1%-100%
71.2x71.2x13.6mm
Product Data
•
ZigBee CCT remote based on ZigBee 3.0
•
Enables to pair ZigBee lighting devices via touchlink
commissioning without coordinator
•
Supports find and bind mode to pair with ZigBee
lighting devices
•
Supports 1 group for binding max. 30 lighting devices
•
2.4 GHz global operation
•
Long battery life mesh technology
•
Transmission range up to 30m
•
Compatible with universal ZigBee Gateway products
•
Compatible with universal CCT ZigBee lighting
devices
16.ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
•
Basic
•
Power Configuration
•
Identify
•
Diagnostics
Output clusters:
•
Identify
•
On/off
•
Level control
•
Ota
•
Color control
55.57 mm
71.20 mm
11 mm
Battery: CR2450
Before the first use, please open the battery
cover and remove the protective film
5
5
.5
7 m
m
7
1
.2
0 m
m
Network pairing mode: click both buttons 3 times to
set the remote into network pairing mode (the remote
should not belong to any gateway network).
Factory reset: click both buttons
3 times to factory reset the
remote (the remote should
already be paired to a gateway).
Quick Start (Simplified operation compared to standard operations in the part “Operation”)
Touchlink:
Press and hold
down both for 3 seconds to
start touchlink and link light
device to the remote.
