5
WarnInG
• When you dispose of your old bar fridges
and freezers, remove any doors. Children can
suffocate if they get trapped inside.
• This appliance contains insulation formed
with flammable blowing gases. Avoid
safety hazards by carefully disposing of
this appliance.
• The appliance must be plugged into its
own dedicated 220-240V, 50Hz AC
electrical outlet.
• Ensure that the electric outlet is properly
earthed to ground. Consult a qualified
electrician if you are unsure.
• The electrical system of this bar fridge must
be connected with an automatic 30mA circuit
breaker and/or residual current device (RCD). If
uncertain have a qualified electrician check your
electrical system before installation and/or use.
• Do not use an extension cord or adaptor plug.
• Unplug the appliance before cleaning.
• Never unplug the appliance by pulling on the
power cord. Always grip the plug firmly, and
pull straight out of the receptacle to prevent
damaging the power cord.
• Chose a location that is not too cold - the
ambient temperature should be above 8
°
C.
• Chose a location that is not affected by direct
sunlight so that the fridge performs to its’
optimal ability.
• Chose a location that is not affected by direct
rain, install undercover only.
• Put the appliance in a dry place, avoiding
areas of high moisture or humidity.
• Don’t put the appliance near stoves, fires or
heaters.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction. Do not use mechanical devices
or other means to accelerate the defrosting
process. Do not use an electrical appliance
inside the appliance.
• If power cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
Protect from Moisture
Avoiding placing the bar fridge in a place where heavy
moisture is present so as to minimise possibility of rusting
of metal parts. The bar fridge should be kept out of water
or direct sprayed water, failure to do this could cause poor
performance and/or an electrical short could occur. Choose a
location that is not affected by direct rain, install undercover
only.
Protect from Heat
The bar fridge should be protected from excessive
heat sources and out of direct sunlight, so that optimal
performance is not affected.
Protect from cold
The bar fridge should be protected from excessive cold
weather and frosts. Suggested minimum ambient temperature
should ideally be higher than 8°C, so that optimal performance
is not affected.
Moving
When moving, the bar fridge cannot be reclined to more than
45°. Any greater angle may damage the cooling system.
Never move the bar fridge while it is plugged in and operating.
Once you have moved the bar fridge, leave standing in a level
position for 4 - 6 hours so that the gas can settle.
Positioning
Ensure the sides, top and rear have at least 10mm clearance
to ensure adequate ventilation.
Never cover the bottom front grill as this is required for correct
ventilation.
After installation the appliance should be left for 4 - 6 hours
before it is switched on in order to allow the refrigerant to
settle.
disposal of old appliances
The majority of components are recyclable, however there are
also dangerous chemicals inside. To dispose of old fridges
remove the doors and contact your local council for recycling
options.
electrical Installation
The electrical system of this bar fridge must be connected
with an automatic 30mA circuit breaker and/or residual current
device (RCD). If uncertain have a qualified electrician check
your electrical system before installation and/or use.
