7 Quick
Steps
Page 15
Mainboard User's Manual
Floppy Disk Drive Connector (34-pin FLOPPY).
This is a 34-pin connector that supports the provided floppy
drive ribbon cable. After connecting the single end to the
on-board “FLOPPY” connector, (O in diagram) connect the
remaining plugs on the other end to the corresponding
floppy drives.
IDE Device Connector.
The on-board IDE connectors (P in diagram) support the
provided 40/80-pin IDE hard disk ribbon cable. After connecting
the single end to the mainboard, connect the remaining plugs
at the other end of your hard disk(s). If you install hard disks,
you must configure the drives by setting its jumpers according
to the documentation of your hard disk.
Also, you may connect the hard disk drives so that both
become Masters, using one ribbon cable on the primary IDE-
connector, and the other on the secondary IDE connector.
NOTE: For the flat ribbon cable connection, please make
sure that the pin 1 of the ribbon cable (the red wire side of
the cable) is correctly connected to the on-board connector's
pin 1 as shown on the “ the mainboard diagram”.
Floppy connection
IDE connection
