G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1
Press the button
. The information display will show the CLOCK signal.
Within approximately one minute the flame will have extinguished.
2
Press the TIMER key
, when you want to switch off the heater and ignite it
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
H
THE INFORMATION DISPLAY
The information display
not only serves as an indicator of the (set) time and
temperature (
Sections C, E, and F
), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE INFORMATION
WHAT TO DO
e - 0
Temperature within the heater too high.
Cool-down and re-ignite.
f - 0
Power interrupted.
Re-ignite the heater.
e - 1
Faulty thermostat.
Contact your dealer.
f - 1
Faulty burner thermistor.
Contact your dealer.
e - 2
Starting problems.
Contact your dealer.
e - 5
Tipping-over protection.
Re-ignite the heater.
e - 6
Poor burning.
Contact your dealer.
e - 7
Room temperature
If necessary,
above 32°C.
re-ignite the heater.
e - 8
Defective booster.
Contact your dealer.
e - 9
Air filter dirty; or
Clean filter
Fuel pump dirty.
Contact your dealer.
The heater has been in operation
continuously for a period of 69 hours
and has turned itself off automatically.
Switch the heater back on.
-- : --
+
Out of fuel.
Refill removable tank.
-- : --
+
Too little ventilation.
Ventilate better.
e - 1 1
+
Too little ventilation.
Ventilate better.
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 69 hours continuous operation. The following will then appear
in the display:
. If desired, you can switch the heater on again by pressing
the button
(see Section D)
.
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code
cl:05
running back to
cl:01
. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
4
80
In case of any
malfunctioning the
information display
will tell you what is the
matter.
p074_087_uk_SRE440E.indd 80
04-06-13 15:11
Summary of Contents for SRE 440 E
Page 21: ...3 17...
Page 150: ......
