7
the unit (over 10m), the connection between speaker and smart-phone will lose, the
unit will go back to Bluetooth standby mode.
6. Ensure the Bluetooth in your smart phone at “searching device” mode, keep on
pressing “Play / Pause button” on the top panel, and then follow above steps to
reconnect it.
AUX-IN (Line in Type)
Require a 3.5 mm cable (included).
1. Connect a 3.5 mm cable to the Aux-in jack. Connect the other end of the 3.5 mm
cable to an MP3 player or other audio source.
2. Press the “
POWER
” button to turn the unit on.
3. Press the “
SOURCE
” button on the top panel or the “
SOURCE
” button on the remote
to switch to Aux-in mode.
4. Use the controls on the connected device to begin playing audio routed through the
unit.
USB PORT FOR PLAYING MP3
1. Power on the unit and insert a USB Flash Drive (not supplied) into the USB Port,
ensuring the plug is fully inserted at the correct way, the LED display will show small
“USB”
2. The tower speaker will play music from the USB automatically or press “
SOURCE
”
button on the remote.
3. The maximum size of Flash Drive that can be supported is up to 32GB.
USB PORT FOR CHARGING
1. USB power output DC
5V 1A
. It supports charging all devices in the power range.
2. When charging a device, ensure that the power supply is the right one for your
device.
PLAYING THE FM RADIO
1. Press the "
POWER
" button to turn the unit on.
2. Ensure that the FM Antenna has been fully extended and press "
SOURCE
" on the
top panel or the “
SOURCE
” button on the remote control to adjust to the "FM" mode.
3. Press “
SKIP FORWARD
” or “
SKIP BACKWARD
” and hold; the unit will scan the
radio station, and stop once it has found one.
4. For fine tuning 0.1MHz, press the “
SKIP FORWARD
” or “
SKIP BACKWARD
” button
once.
PROGRAMMING & PLAYING OF FM RADIO PRESETS
1. Follow the steps for Playing the FM Radio.
2. Press the "
SCAN/MEMORY
" button for a long time on the remote to search and
preset stations in memory (i.e. “P01” – this will blink on the display - and then the
preset station frequency number will be shown on the display).
