•the temperature of the electric soldering irons can reach more than 160 ,if the
℃
animal or man touch the metal heated by the electric soldering irons, we will suffer
seriously bum.
•It supposes that the weld machine should not be operated under high temperature
all along.
•It is totally prohibited to put the electric soldering irons into the water in order to
cold it.
•the electric soldering irons and the weld machine can not carry too much man’s
weight.
•the weld machine will become very hot, so it can only be installed on the
steady ;Fastened and no easily burned shelf. The groove for blowing wind on the
weld machine’s crust mustn’t be covered.
•when welding the lead and touching points, please pay attention: Take appropriate
measures to protect and cover up the metals, in case that they will touch each
other.
•If it needs maintenance, we must get through the power or turn on the crust; Now
the electrified metal, touching points and the capacitors are uncovered, in such
cases, only the professionals are allowed to weld in case of the danger of life loss.
•when maintaining , please choose the producer’s recommend product, such as
solder, soldering fluid est.
•please clean up the outer components of the crust after turning off the weld
machine and cut off the power, but you have to use the ash hair brush and the
softened and wet brush(disallow the strong cleaning usage, spray or melting
agent )`. Notice: when cleaning, the fluid can not be flowed along aside into the
weld machine from the opening point of the crust.
•the fuse may burn out due to over carry, so please use the same model number for
preparation(T500mA\250fu, 5*20 millimeter). It is prohibited to connect the
damaged fuse or use some other characterized fuse. When substitute the fuse, you
must turn off the weld machine and cut off the power. And then apply the screw to
open the fuse on the back of the weld machine; disassembly the burned fuse; and
substitute the good fuse and then cover the fuse box.
•Preparation
Please conserve the weld machine’s packing box. In case that we use it for future
transportation or put the weld machine into it when we don’t need it ,so as to avoid
pollution of ash and the eroding of the wet.
1. put the metal helix of screw frame into the corresponding open crust of the
electric soldering irons frame. And use the screw to fasten it and so does the
bottom of the frame.
2. Please let the sponge for tidying up glue absorb enough clean water and drop to
dry, and then put it on the salver.
3. Fix the frame on the right side of the weld machine (connecting in gap)
Instruction: Don’t use the electric soldering iron without soldering mouth
because it will damage the heating component and temperature sensor.
Electric connect
1. Please connect the electric soldering iron with the weld machine by means of
insetting the plug of the electric iron lead (a diode plug with 5 conjunctions and
180
degrees lead trough) into the electrical outlet on the face of the weld machine.
2. Turn off the switch of the power supply (0 location), and inset the power supply
plug of the weld machine lead into the electrical jack whose voltage conforms with
what is marked on the data plate. At that time, the weld machine is ready for work.
Temperature regulating
1. Put the power supply switch to location 1 and the weld machine is being
connected. At that time the lower line on the screen will display a set temperature
4
5
