Zhone IMACS 8000, User Manual

Page: 547 / 788

Server Cards 20-3
Analog Bridging Server Card Analog Bridge Server Card User Screens and
Settings
20.3 Analog Bridge Server Card User Screens and Settings
20.3.1 Analog Bridge Provisioning
Bridge setup and participant provisioning is done from the Analog Bridge card itself. To start
potential bridge participants should be in an un-provisioned state, or in stdby mode at the
card/port level.
20.3.2 Analog Bridge Server Card Main Configuration Screen
On the Analog Bridge card main configuration screen, all the bridges will show up initially in
standby mode. When a Bridge is in standby mode, all ports on that particular bridge will be
turned off automatically. The bridge must be active in order to activate the individual ports.
To enter the provisioning screen, position on the Bridge card from the main IMACS window
and depress carriage return. A screen similar to Figure 20-2 below appears.
Figure 20-2.Analog Bridge Server main screen
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase key. Table
20-1 summarizes these actions. For example, after you configure the Analog Bridge Card
ports, press “s” to save your settings.
Table 20-1. Analog Bridge Main Screen Actions
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refr Refresh - Updates certain time-related information fields that are not
automatically updated (i.e., test status). Refresh will also compact and
reorder all the ports in the LogUNIT sequence.