To start the tool, simply pull the switch trigger. Tool
CAUTION:
speed is increased by increasing pressure on the
• Always check the direction of rotation before
switch trigger. Release the switch trigger to stop.
operation.
Lighting up the front lamp
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
1. Lamp
rotation before the tool stops may damage the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
CAUTION:
Installing or removing driver bit or socket bit
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
Use only the driver bit or socket bit shown in the figure.
lower the illumination.
Do not use any other driver bit or socket bit.
Reversing switch action
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from
1. Bit
the A side for clockwise rotation or from the B side for
2. Sleeve
counterclockwise rotation.
To remove the bit, pull the sleeve in the direction of the
When the reversing switch lever is in the neutral
arrow and pull the bit out firmly.
position,the switch trigger cannot be pulled.
6
Summary of Contents for CDL1801
Page 9: ...9...
