K207A Swing Gate Opener User’s Manual
(1) Learn / erase remote controls
Adding extra remote controls (Learn): Press red button on the control board (see Fig.14 No.12), then
the ‘LED’ (see Fig. 14 No.11) will be on, it will turn off when you press any remote control button.
Press the same button, the ‘LED’ will flash at 2Hz frequency and then turn off; this indicates the
learning process is finished. If it fails to set, the ‘LED’ will turn off automatically after flashing for 1
second, you should follow the steps above to reset.
Up to 25 remote controls may be used.
To erase all remote controls: press and hold the red button on the control board until ‘LED’ turns on
and then turns off. This indicates that all the remote controls have been erased completely. You
should reprogram the remote control if you want to control this opener (see Adding extra remote
controls section).
(2) The remote control works in a single channel mode. It has four buttons. See Fig. 13. With each
press of the remote control button which has been programmed, the gate will close, stop, open or
stop cycle.
Warning: Notify the users that the gate is never to be operated unless it is in full view.
(3) Operation of the gates
The gates can be controlled by using remote control, single-button mode or three-button mode
external button switch.
z
Unlock the gate opener with the key. Push the gates to the opened (retracted) position manually.
Lock the gate opener with the key
z
Turn the power on.
z
Close the gates by using remote control, single-button mode or three-button mode external
button switch. The No.2 gate-leaf will close first, and then the No.1 gate-leaf with electrical lock
will close after 3 seconds.
z
The gates will stop at its closed position automatically, or you can stop the gates at its closed
position by remote control, single-button mode or three-button mode external button switch. If
gates do not stop or bind before stopping, verify that the stop is firmly in place, and the force
adjustment knob for that gate on the control board is adjusted correctly. Adjust counter-clockwise
to reduce binding.
z
Open the gates by remote control, single-button mode or three-button mode external button
switch. Firstly, the electrical lock will be opened, the No.1 gate-leaf with lock will open, and then
the No.2 gate-leaf will open after 3 seconds.
z
The gates will stop at its opened position automatically, or you can stop the gates at its opened
position by remote control, single-button mode or three-button mode external button switch. If
gates do not stop or bind before stopping, verify that the stop is firmly in place, and the force
adjustment knob for that gate on the control board is adjusted correctly. Adjust counter-clockwise
to reduce binding.
z
Total working time: 24 seconds.
Note:
The gate will return to open if press ‘OPEN’ button on the three-button mode external button
switch during closing, the beeper will ring. We call this
Open priority
.