5
Installing the Device
Leave a minimum space of 30 cm at the front and back sides of the
device, and a minimum space of 10 cm at the left and right sides of the
device for heat dissipation. If the device is installed in a cabinet, keep a
minimum space of 1U at the top and bottom for heat dissipation.
Installation on a Workbench
1.
Remove the stickers of the supplied foot pads and attach the foot
pads to the bottom of the device.
2.
Place the device on a clean and stable workbench and the
installation completes.
CAUTION!
Keep your device from the vibration source, for example, the electric
generator. Keep your device from direct air flow from air
conditioners or fans.
Do not stack your device or put any heavy object on it.
Use foot pads to avoid vibration and heat dissipation problems.
Use shelves and slide rails to bear the weight of the device instead
of using suspension loops only.
Installation in a Cabinet
1.
Attach a suspension loop to the chassis with the screws
aligned with the screw slots, and then secure the suspension
loop with two screws (M4x8).
2.
Use the same method to install the other suspension loop.
1: Four screws
2: Ellipse hole
3: Suspension loop
1 2
3
