14
Step 3
Draw and then dig three plastic expansion bolts holes on ceiling or other installation surface and then
insert three expansion bolts in the holes. Secure these three bolts firmly.
Note:
Please dig a “cable exit hole” in the surface according to the installation map if you want to draw
out the cable from the top of the installation surface.
You need to use the proper tool to open up the side port of the U-cable channel of the dome
camera pedestal if you want to draw out the cable from the side port of the cable channel when
you are installing the device cable. And then you can draw out the cable from the cable channel of
the pedestal.
Step 4
Adjust the device installation pedestal to the proper position and then draw the cable through the cable
exit you just dug in the ceiling (wall). Line up the TOP direction of the device to the installation map
and then line up the three screw holes in the device pedestal to the three plastic expansion bolt holes
in the installation position. Put the three self-tapping screws in the three plastic expansion bolts firmly.
Now the dome camera is secure in the installation surface.
Step 5
Loosen the two M3 secure screws of the lens rotation structure (Do not remove, loosen a little bit will
be OK.). Use the inner hexagonal wrench to insert them to the inner hexagonal holes and then use the
wrench to turn the lens. Adjust the lens to the proper monitor angle and then secure the screws of the
lens rotation structure. The lens adjust angle ranges are: flip (0°~+75°), video pan rotation (-15°~+15°) ,
video rotation angle(-15°~+15°).
Step 6
Line up the dome camera cover to the cable exits and put the cover back. Use the inner hexagonal
wrench to secure the three inner hexagonal screws firmly. Now the installation completed.
Note:
If you want to restore default settings of device, you shall open device front cover, and press
Reset button in Figure 3-2 with power on for 10s.
If you want to use WPS function of device, you shall open device front cover, and press Reset
button in Figure 3-2 with power on for 1-2 seconds, then press the WPS button of the router,
generally the device will connect to corresponding router within one minute (supported by
some series)
