13
Operational Requirements
1. Place the instrument on a workbench or similar surface.
2. Before operation, please make sure that the ambient temperature is
+0
℃
~ + 40
℃
(+32
℉
~ +104
℉
)
WARNING:
To ensure normal heat dissipation, please do not stack objects on
the front, sides, or back of the instrument. A ventilation space at least 3cm
should be reserved at the side and back of the instrument, to ensure air
circulation of the instrument.
WARNING:
Before using the product and any related instruments, you should
ensure that all security precautions listed in this manual are followed. Although
some instruments and accessories are only used under non-hazardous voltages,
danger may also occur. Only qualified personnel are allowed to use this product
because they need to be able to recognize risk of electric shock and be familiar
with necessary security precautions, to avoid possible injuries. Before use,
you are recommended to read and follow all regulations of installation,
Operation and maintenance information carefully. For complete product
technical specifications, please refer to this manual. Before performing any
maintenance, you should disconnect the power line and all test cables.
Operators of this instrument must take protective measures against electric
shock at all times. The responsible agency must ensure that operators cannot
touch any connection points and/or maintain insulation from each connection
point. In some cases, the connection point must be exposed, which may cause
physical contact. In this case, operators must be trained to know how to protect
themselves from the risk of electric shock. Provided that circuits can work
normally at 72 volts or higher, any conductive parts in
the circuits must not be exposed.
WARNING:
Please use wires with an appropriate rated load. The capacity of all
load wires must be able to carry the maximum short-circuit output current of the
power supply, without overheating. If there are multiple loads, each pair of load
wires should safely bear the full rated short-circuit output
current of the power supply.
WARNING:
Do not loosen any screws on this product. There are no
user-serviceable components inside.
WARNING:
In order to reduce the risk of fire and electric shock, you should
refer to the range of rated values of the power supply.
System Installation
■
Open package of the instrument and check whether you have received all
the items listed in the “standard accessories”.
■
Also, check you have received all other accessories ordered with the
instrument or not.
■
Please visit zhaoxin website (www.zhaoxinpower.com)
for the latest information.
Please perform the following steps, to confirm that the power supply is ready:
Power on and off the Instrument Power
Please power on the instrument power and perform the following steps:
1. Complete all connections.
2. Connect the power line provided with the instrument to the power connector
on the rear panel. Then, connect the power line plug to a properly grounded
power socket.
